![late 2008 macbook pro black screen fix late 2008 macbook pro black screen fix](https://cdn-60c35131c1ac185aa47dd21e.closte.com//wp-content/uploads/2016/12/back-screen-mac.jpg)
Place your opened MacBook Pro on a table as pictured. MacBook Pro 13' Retina (Late 2013-Early 2015) Left Speaker Replace a used left speaker for your Late 2013 to Early 2015 model A1502 MacBook Pro 13' Retina laptop and fix issues with sound output. I can just choose sleep from the Apple Menu every time, or put a tiny "refrigerator" magnet on the right side of the display. Open your MacBook Pro so the display is perpendicular to the upper case. In some cases, the MacBook is unresponsive and seems to be stuck at the 'black screen of death', while in other cases, you may notice the MacBook is turned on because you can hear the startup chime, while the screen is black. So while the display works perfectly and the hinges, camera cable, and LVDS cable match, the reed switch magnet is on the left side now (that meets the ExpressCard/34 slot, instead of the SD Card slot) instead of on the right (near the security slot) where the actual reed switch is for the late-2008 MacBook Pros. A MacBook Pro can sometimes go black after waking from sleep. So I didn't notice this until I tried to close the MacBook and the backlight stayed on. The magnet for the reed switch on the mid-2009 display is about halfway up the left side of the display.
![late 2008 macbook pro black screen fix late 2008 macbook pro black screen fix](https://media.wired.com/photos/616dbbeff33cc831b4f06e62/1:1/w_1800,h_1800,c_limit/Gear-Apple-Macbook-Pro-2021-Photoshop.jpg)
I tested this by holding a broken display (which has lots of magnets across the top) near the right side and this 2.53 GHz late-2008 Unibody MacBook Pro went to sleep. The reed switch that causes the computer to sleep when closing the display is on the other side. I have to add to my previous comment about switching a mid-2009 15 inch MacBook Pro display to a late 2008 MacBook Pro. (Also, the camera cable where it attaches the logic board was slightly closer to the optical drive and seemed to overlap it slightly when transferring the Mid-2009 display to the Late-2008 MacBook Pro. That's easy enough, just remove the captive screws from the cables to keep them with the same MacBook Pro they were from. The other screws did appear to be identical though.īottom line, keep the screws to the same MacBook. Meaning, keep all the screws with the same MacBook Pro.
#Late 2008 macbook pro black screen fix how to
I wanted to report that I successfully removed the display assembly from a Mid-2009 MacBook Pro (2.53 GHz - no discrete graphics) and installed it on the Late-2008 MacBook Pro (2.53 GHz with dual graphics).Įverything appears to be identical, except (strangely) the screws, that are generally captive in the camera cable and the LVDS cable, need to stay with their original MacBook Pro. If your MacBook Pro stuck on white screen, do you know how to fix it In this post, MiniTool Software will show you some solutions that are proved to be effective. I also read the guide pertaining to the 2.53 GHz Mid-2009 MacBook Pro Display Assembly.